: All operator cables connect to the Processor Card located inside the operator's rear lid.
Elias grinned. He had done it. He had tamed the beast. He picked up the manual to put it back in the box, noticing for the first time that there was a final page—a single sheet of paper tucked into the back cover, printed in red ink. crawford cdm9 950 installation manual
Switch the power and then ON to initiate the installation sequence. Calibration: Mark a position on the door track 1 meter above the floor. Set the SW1 switch to " ON " on the manoeuvring card. : All operator cables connect to the Processor
Connect sensors like the OSE (Optical Safety Edge) and any additional photocells to the maneuvering card. He had tamed the beast
Baud rate, parity, and device address are set via the COMM menu. The factory default is 9600 baud, 8 data bits, 1 stop bit, no parity (8N1).
Do not auto-tune on an empty chamber (no product load) if you will later run a full load. The PID values will be too aggressive. Always auto-tune under typical load conditions.